Honda Civic 2002-2003 Service Manual page 1067

SRS
DTC Troubleshooting (cont'd)
OTe 4-3: Short to Another Wire or Decreased
Resistance in Front Passenger's Seat Belt
Tensioner
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead C 07TAZ-SZ5011A
• SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC memory (see page 23-261.
2. Turn the ignition switch ON (III, and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO-Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-261.
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger's seat belt
tensioner
2P
connector
(A)
from the floor wire
harness.
"
:
A
07TAZ·SZ5011A
5. Connect the SRS inflator simulator (2
Q
connectorl
and simulator lead C to the floor wire harness.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
23-60
8. Read the DTC.
Is OTC 4-3 indicated?
YES-Go to step 9.
NO-Short in the front passenger's seat belt
tensioner; replace the front passenger's seat belt
(see page 23-41 .•
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect the floor wire harness 4P connector
C403 (AI from dashboard wire harness B.
11. Connect the SRS inflator simulator (2
Q
connectorsl and simulator lead F to dashboard wire
harness B.
12. Reconnect the battery negative cable.
13. Erase the DTC memory.
14. Read the DTC.
Is OTC 4-3 indicated?
YES- Go to step 15.
NO-Short in the floor wire harness; replace the
floor wire harness .•
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.