SRS
OTe Troubleshooting (cont'd)
13. Check voltage between the No. 10 terminal of SRS
unit connector A (lap) and body ground. There
should be 1 V or less.
SRS
UNIT
CONNECTOR A (18P)
=
Wire side of female terminals
Is the voltage as specified?
YES-Go to step 14.
NO-Short to power in the engine compartment
wire harness or dashboard wire harness 8; replace
the faulty harness .•
14. Turn the ignition switch OFF.
15. Connectthe SRS inflator simulator (jumper
connector) and simulator lead H to the engine
compartment wire harness 2P connector (A).
~
A~
/07YAZ-S3AA100
/07SAZ.TB4011A
-tJ
Gi
23-78
16. Check resistance between the No. 10 and No.1 1
terminals of SRS unit connector A (lap). There
should be 1
Q
or less.
SRS
UNIT
CONNECTOR A (18P)
Wire side of female terminals
/s the resistance as specified?
YES-Faulty left front impact sensor or SRS unit;
replace the left front impact sensor (see page 23-125).
If the problem is still present, replace the SRS unit
(see page 23- 1 22) .•
NO-Poor connection at C401, faulty engine
compartment wire harness, or faulty dashboard
wire harness B. Inspect C401. If it is OK, replace the
faulty harness .•