Ricoh G188 Service Manual page 83

punch unit board (
The cables [E] are coiled and attached to the PCB.
6. Attach the slide drive unit [F] to the finisher and connect it to the punch unit (
x 1). Push in the slide drive unit at (1) when you attach the screw (2).
7. Make sure that the punch unit moves freely and is not blocked by the screws.
8. Put the side-to-side detection unit [G] in the machine. Make sure that the two pins are
engaged correctly at the front.
9. Make sure that the side-to-side detection unit moves smoothly on its rails. If it does not,
make sure that the rails are aligned with their grooves.
10. Attach the side-to-side detection unit and connect it at the rear (
1).
11. Pull the short connector out of the connector [H] then connect the cable of the finisher
( x 1).
SM
x 2, x 1).
2-43
Punch Unit (B702)
x 2,
x 2, x 1, x
G188/G189