Ricoh G188 Service Manual page 631

041 This SP must be executed immediately after installation of an HDD unit in a
basic machine that previously had no HDD. The first time the machine is
powered on with the new HDD installed, the system automatically takes the
address book from the NVRAM and writes it onto the new HDD. However, the
new address book on the HDD can be accessed only by the system
administrator at this stage. Executing this SP by the service technician
immediately after power on grants full address book access to all users.
Procedure
1. Turn the machine off.
2. Install the new HDD.
3. Turn the machine on.
4. The address book and its initial data are created on the HDD automatically.
5. However, at this point the address book can be accessed by only the
system administrator or key operator.
6. Enter the SP mode and do SP5846-041. After this SP executes
successfully, any user can access the address book.
043 Addr Book Media
Initialize Local Addr
047
Book
Initialize Delivery Addr
048
Book
Initialize LDAP Addr
049
Book
050 Initialize All Addr Book
SM Appendix
Displays the slot number where an address book
data is in.
[0 to 30 / - /1]
0: Unconfirmed
1: SD Slot 1
2: SD Slot 2
4: USB Flash ROM
20: HDD
30: Nothing
Clears the local address book information,
including the user code.
Clears the distribution address book information,
except the user code.
Clears the LDAP address book information, except
the user code.
Clears all directory information managed by UCS,
including all user codes.
8-219
Engine Service Mode
G188/G189