Ricoh G188 Service Manual page 436

Engine Service Mode
1113 [Stand-by Time]
Shift Time
Specifies the interval from the ready mode to the stand-by mode.
001
If the machine does not do any printing job for the time specified with this SP
after the heating roller has reached the ready temperature, the machine
returns to the stand-by mode.
After Recovery
003
Specifies the time for keeping the target temperature after recovery
(SP1105-083) without any jobs.
004 Time After Paper Feed
006 Offset: Center and Ends
1115 [Stand-by Idling]
Interval
001
Specifies the interval between idling during stand-by mode.
This idling during the stand-by mode prevents the roller deformation.
Idling Time
002
Specifies the length of each idling operation during stand-by mode.
1117 [Idling Time After Heater OFF]
Time After Heater OFF
002
Specifies the idling time without the lamp on after job end.
This idling prevents the heating roller overheating after job end.
1118 [Curl Temperature Correction]
001 ON/OFF
G188/G189
*ENG
[0 to 180 / 60 / 1 sec/step]
*ENG [0 to 60 / 10 / 1 sec/step]
*ENG
[0 to 10 / 0 / 1 sec/step]
*ENG [0 to 100 / 100 / 1 deg/step]
*ENG [1 to 240 / 60 / 1 min/step]
*ENG [0 to 60 / 0.7 / 0.1 sec/step]
*ENG [0 to 20 / 0 / 1 sec/step]
[0 or 1 / 0 / 1]
*ENG
0: OFF, 1: ON
8-24 SM Appendix