Ricoh G188 Service Manual page 246

Using the Debug Log
1 Engine SC Error
2 Controller SC Error
3 Any SC Error
4 Jam
More than one event can be selected.
- Example 1: To Select Items 1, 2, 4
Push the or
selection. This example shows "Engine SC Error" selected.
- Example 2: To Specify an SC Code
Push the or
with the or
For details about SC code numbers, please refer to the SC tables in
"Appendices".
6. Select one or more memory modules for reading and recording debug information.
Select "SP5859".
Under "5859" press the necessary key item for the module that you want to record.
Enter the appropriate 4-digit number with the
Refer to the two tables below for the 4-digit numbers to enter for each key.
The following keys can be set with the corresponding numbers. (The initials in
parentheses indicate the names of the modules.)
4-Digit Entries for Keys 1 to 10
Key No.
1 2222 (SCS)
2 14000 (SRM)
G188/G189
Saves data when an engine-related SC code is
generated.
Saves debug data when a controller-related SC Code
is generated.
Saves data only for the SC code that you specify by
entering code number.
Saves data for jams.
key to select the appropriate items(s). Press the "OK" key for each
key to select "3 Any SC Error", enter the 3-digit SC code number
key. Then press"OK" key. This example shows an entry for SC670.
Printer
or key. Then press"OK".
5-14 SM