Ricoh G188 Service Manual page 429

in 600 dpi mode.
F :1bin: Paper Feed:
Pressure Temp
041
Specifies the threshold of the pressure roller for the paper feed to the 1bin tray
in 1200 dpi mode.
1105 [Fusing Temperature] Fusing Temperature Adjustment
(Printing Mode, Roller Type, [Color], Simplex/Duplex)
Roller Type –> Center and Ends: Heating roller, Pressure –> Pressure roller
Paper Type -> Plain, Thin, Thick, OHP, Middle Thick, Special
Fusing Ready Temp.
001
Specifies the heating roller target temperature for the ready condition.
Fusing Ready: Offset
002 Sets the heating roller offset temperature for the printing ready condition.
Ready temperature = (Target temperature specified in SP1-105-1) –
Temperature specified in this SP mode
Fusing Ready Temp: H
007
Sets the heating roller offset temperature at the end of the heating roller. This
value is one of the thresholds to determine if the machine is at the heating
roller target temperature during warm-up.
Ready Target Add
Pressure
008
Sets the upper limit temperature of the heating roller at the end of the heating
roller. This value is one of the thresholds to determine if the machine is at the
heating roller target temperature during warm-up.
012 Stand-By: Pressure
SM Appendix
*ENG [20 to 120 / 80 / 1 deg/step]
[150 to 200 / P2c: 165, P2d: 170 / 1
*ENG
deg/step]
*ENG [0 to 100 / 5 / 1 deg/step]
[150 to 200 / P2c: 165, P2d: 170 / 1
*ENG
deg/step]
*ENG [0 to 200 / 80 / 1 deg /step]
* ENG
[60 to 130 / 90 / 1 deg/step]
8-17
Engine Service Mode
G188/G189