Ricoh G188 Service Manual page 241

interrupted
33 Incorrect SD card version
Module mismatch - Correct
34 module is not on the SD
card)
Module mismatch – Module
35 on SD card is not for this
machine
Cannot write module –
36
Cause other than E34, E35
Engine module download
40
failed
Operation panel module
42
download failed
Stamp data module
43
download failed
Controller module download
44
failed
Electronic confirmation check
50
failed
SM
module download, then repeat the installation
procedure.
Incorrect ROM data on the SD card, or data is
corrupted.
SD update data is incorrect. Acquire the correct
data (Japan, Overseas, OEM, etc.) then install
again.
SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct
update data then install again.
SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct
update data then install again.
Replace the update data for the module on the
SD card and try again, or replace the EGB
board.
Replace the update data for the module on the
SD card and try again, or replace the LCDC.
Replace the update data for the module on the
SD card and try again, or replace the hard disks.
Replace the update data for the module on the
SD card and tray again, or replace controller
board.
SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct
update data then install again.
5-9
Firmware Update
G188/G189