Ricoh G188 Service Manual page 434

Engine Service Mode
10s Forced Ready
008
ON/OFF
009 10s Forced Ready Time
1109 [Fusing Nip Band Check]
001 Execute
Pre-Idling Time
002
Specifies the fusing rotation time before executing SP1109-001.
Stop Time
003
Specifies the time for measuring the nip.
Pressure Position
004
Specifies the pressure position for measuring the nip.
1110 [Pressure Release]
Shift Time
001
Adjusts the time when the pressure roller moves from the pressing position to
the no-pressing positon.
002 Feed Pressure: 1
003 Feed Pressure: 2
004 Feed Pressure: 3
005 SC Detection
G188/G189
[0 or 1 / 1 / 1]
*ENG
0: OFF, 1: ON
*ENG [0 to 20 / 9.0 / 0.1 sec/step]
[0 or 1 / 0 / 1]
Executes the nip band measurement
between heating roller and pressure
- roller.
If the nip band width is not 8 mm, and
fusing is not good, replace the pressure
roller or install a new fusing unit.
*ENG [0 to 255 / 240 / 1 sec/step]
* ENG
[5 to 30 / 10 / 1 sec/step]
* ENG [0 to 3 / 0 / 1 ]
*ENG [0 to 240 / 1 / 1 min/step] DFU
*ENG
Not used
* ENG
[0 to 700 / 0 / 1 msec/step]
* ENG
* ENG DFU
8-22 SM Appendix