Table of Contents
Advertisement
CHAPTER 8
Transceiver and Cable Specifications
Pluggable Transceivers Supported on EX2300 Switches
Copyright © 2017, Juniper Networks, Inc.
Pluggable Transceivers Supported on EX2300 Switches on page 73
Pluggable Transceivers Supported on EX Series Switches on page 97
SFP+ Direct Attach Copper Cables for EX Series Switches on page 99
Management Cable Specifications on page 105
Understanding EX Series Switches Fiber-Optic Cable Signal Loss, Attenuation, and
Dispersion on page 106
Uplink ports on the front panel in EX2300 switches support SFP and SFP+ transceivers.
This topic describes the optical interfaces supported for those transceivers. It also lists
the copper interface supported for the SFP transceivers. For the full specifications of
these transceivers, see
The Hardware Compatibility Tool
NOTE:
We recommend that you use only optical transceivers and optical
connectors purchased from Juniper Networks with your Juniper Networks
device.
CAUTION:
If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical Assistance Center
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommend that you check the third-party optic or cable and potentially
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
NOTE:
EX2300-C switches ensure normal operation in the temperature range
32° F (0° C) through 104° F (40° C) at altitudes up to 5,000 ft (1,524 m).
In the temperature range 104° F (40° C) through 113° F (45° C) at altitudes
up to 5,000 ft (1,524 m), use extended temperature range SFP transceivers.
.
73
Hide quick links:
Advertisement
Table of Contents
