Operation Using Digsi ® 4 - Siemens siprotec 7SA6 User Manual

Initial Inspections
3.3.2 Operation Using DIGSI
®
DIGSI 4 User
Interface
3-8
®
4
®
DIGSI 4 has the typical PC application Windows operating environment to guide the
user. The software has a modern, intuitive, user-interface. Further details are found in
Section 4, as well as in the DIGSI
Some applications of DIGSI
measurement values, reading messages, and setting the time clock. The handling of
the operator control windows of DIGSI
simple examples as described below. To perform the steps in the examples, first
connect the SIPROTEC
with the equipment. To accomplish this:
q
Establish a physical connection between a serial interface of the PC and the
operating serial interface of the device on the front panel.
q
®
Open the DIGSI 4 application in the PC.
q
Generate a new project by clicking on )LOH → 1HZ in the DIGSI
bar.
Figure 3-4 Dialogue box to open a new project in DIGSI
q
Enter a name for the new project in the 1DPH entry field (e.g. test 1) and close the
box with 2..
q
Select )ROGHU by clicking on the item in the newly opened window. Then click in
the menu bar the item 'HYLFH and select the option ',*6, ! 'HYLFH 3OXJ
3OD\ , as shown in Figure 3-5. The Plug & Play dialogue box opens, as shown in
Figure 3-6.
®
4 handbook "Device Configuration".
®
4 which are described below concern viewing the
®
4 can be learned quickly by following the
®
4 device to the PC and match the DIGSI
®
4 interface data
®
4–Manager menu
®
4
7SA6 Manual
C53000-G1176-C133-1