Siemens siprotec 7SA6 User Manual page 502

Control During Operation
7-18
The measured values are divided into the following groups:
01 2SHUDWLRQ SUL
02 ,((SULPDU\
03 ,PSHGDQFH 3ULP
04 6\QFKU&KHFNSUL Measured values of synchronism check, primary;
11 2SHUDWLRQ VHF
12 ,((VHFRQGDU\
13 ,PSHGDQFH 6HF
21 3HUFHQW
31 'HPDQG
32 0LQ0D[ 'HPDQG
33 8,0LQ0D[
34 SFRVϕ0LQ0D[
41 7KHUPDO 0HWHU
51 8VHU 'HILQHG
61 6HW 3RLQWV
71 6HW SRLQWV 09 See Subsubsection 7.1.3.3
81 5HVHW
If a measured value is not available, then instead of the measured value, 3 dots
appear. If the value is undefined (e.g., cos ϕ, when no current is flowing), then "–––"
appears (3 horizontal bars). If a measured value overruns, then "
is displayed.
Use the key to select the measured value group that has the values desired, and
switch to the display of this group with the
the display of operating measured values.
0($685(0(17

!2SHUDWLRQ SUL
!2SHUDWLRQ VHF
Etc.
Figure 7-20 Viewing operating measured values on the front display
Move up and down in the table of measured value groups using the
Operational measured values, primary.
Measured values of earth fault, primary;
Operational impedance, primary;
Operational measured values, secondary;
Measured values of earth fault, secondary;
Operational impedance, secondary ;
Operational measured values, in percent of operational
nominal quantities;
Long-term average values, in primary values;
Minimum and maximum average values with date and time
indication of moment of occurrence, in primary values;
Minimum and maximum values of voltages and currents
with date and time indication of moment of occurrence, in
primary values;
Minimum and maximum values of the actve, reactive and
apparent power of the frequence and the power factor;
Thermal measured values of the overload protection, if
available;
Measured values that are defined by the user during initial
setting of the device (see Section 5.2).
See Subsubsection 7.1.3.2
See Subsubsection 7.1.3.4.
key. Figure 7-20 shows an example for




" (3 asterisks)
23(5$7,21 35, 

!,/ $
!,/ $
Etc.
and
C53000-G1176-C133-1
keys.
7SA6 Manual