Siemens siprotec 7SA6 User Manual page 372

Functions
5th to 8th
reclosure cycles
6-190
For the 2nd cycle:
Address  $5 67$57; determines if starting in 2nd cycle is allowed at all
Address  $5 7$&7,21; action time for the 2nd cycle
Address  $5 7GHDG )OW; dead time after 1-phase starting
Address  $5 7GHDG )OW; dead time after 2-phase starting
Address  $5 7GHDG )OW; dead time after 3-phase starting
Address  $5 7GHDG7ULS; dead time after 1-pole tripping
Address  $5 7GHDG7ULS; dead time after 3-pole tripping
Address  $5 7GHDG (9; dead time in case of sequential fault
Address  $5 &%" &/26(; check CB ready before reclosure
Address  $5 6\Q5HTXHVW; sync. check after 3-pole tripping
For the 3rd cycle:
Address  $5 67$57; determines if starting in 3rd cycle is allowed at all
Address  $5 7$&7,21; action time for the 3rd cycle
Address  $5 7GHDG )OW; dead time after 1-phase starting
Address  $5 7GHDG )OW; dead time after 2-phase starting
Address  $5 7GHDG )OW; dead time after 3-phase starting
Address  $5 7GHDG7ULS; dead time after 1-pole tripping
Address  $5 7GHDG7ULS; dead time after 3-pole tripping
Address  $5 7GHDG (9; dead time in case of sequential fault
Address  $5 &%" &/26(; check CB ready before reclosure
Address  $5 6\Q5HTXHVW; sync. check after 3-pole tripping
For the 4th cycle:
Address  $5 67$57; determines if starting in 4th cycle is allowed at all
Address  $5 7$&7,21; action time for the 4th cycle
Address  $5 7GHDG )OW; dead time after 1-phase starting
Address  $5 7GHDG )OW; dead time after 2-phase starting
Address  $5 7GHDG )OW; dead time after 3-phase starting
Address  $5 7GHDG7ULS; dead time after 1-pole tripping
Address   $5 7GHDG7ULS; dead time after 3-pole tripping
Address   $5 7GHDG (9; dead time in case of sequential fault
Address   $5 &%" &/26(; check CB ready before reclosure
Address   $5 6\Q5HTXHVW; sync. check after 3-pole tripping
If more than 4 cycles have been selected during the configuration of the scope of
functions (section 5.1), the cycles following the fourth cycle operate with the same
settings as the fourth cycle.
7SA6 Manual
C53000-G1176-C133-1