Energy - Siemens siprotec 7SA6 User Manual

Control During Operation
7.1.3.2

Energy

Reading out
Metered Values
From the
Device Front
7-20
appears (3 horizontal bars). If the measured value overruns, then "
are viewed.
Double click on the desired measured value group, e.g. 3ULPDU\. The next sub-group
is displayed.
Double click on the desired sub-group, e.g. 2SHUDWLRQDO YDOXHV SULPDU\.
By double clicking on an entry in the list in the right part of the window, detailed
information on the measured value group is displayed in another window, as shown in
Figure 7-22.
Figure 7-22 Example of measured values shown in DIGSI
In the maximum scope of device 7SA6 there are counters that summarize the active
and reactive power (:S :T) separately according to output and input of the active
energy or capacitive and inductive reactive power (in direction to the protected object).
It is a prerequisite that the direction is configured to IRUZDUG (Address , see
Section 6.1).
With the device ready for operation, first press the
key to select the menu item 0HDVXUHPHQW (See Figure 7-1), and switch
Use the
to the list of measured values using the
There, select the menu item (QHUJ\ with the
using the key.
Use the and keys to move up and down in the table of the energy.
key to return to the 0($685(0(17 submenu. Use the
Use the
the 0$,1 0(18.
®
4
key. The 0$,1 0(18 appears.
MENU
key. The 0($685(0(17 selection appears.
key, and switch to the table of energy

" (3 asterisks)
key to return to
MENU
7SA6 Manual
C53000-G1176-C133-1