Siemens siprotec 7SA6 User Manual page 523

From the
Device Front
:
From PC with
®
DIGSI 4
7SA6 Manual
C53000-G1176-C133-1
With a device ready for operation, first press the
key, highlight the menu item 7HVW'LDJQRVH, and then press the
Using the
key to enter sub-menu. 7(67',$*126( will appear at the top of the menu.
At this point, highlight the menu item 7HVW (QDEOH using the
key to enter sub-menu. 7(67 (1$%/( will appear at the top of the menu. See
the
Figure 7-38.
7(67 ',$*126(

'HYLFH 5HVHW
!7HVW (QDEOH
%ON 'DWD 7UDQV²!
+DUGZDUH 7HVW ²!
6HW5HVHW
6,(0(16 ,QWHUQ
Figure 7-38 Applying Test Mode from the Operator Control Panel
To start 7HVW PRGH, press the
diagnostics) and confirm with the
21 and 2)). Use the
key. The question "$UH \RX VXUH"" is displayed. Highlight the desired response and
press the key. If the mode is changed, the footer shows the message "&RQWURO
ENTER
([HFXWHG" for a short time.
key to return to the 7(67',$*126( level; press the
Use the
the 0$,1 0(18.
The procedure for changing the Block Data Transmission mode is the same. See
Figure 7-39 (simplified).
7(67',$*126(

!%ON 'DWD 7UDQV²!
+DUGZDUH 7HVW ²!
Figure 7-39 Applying a Block of Data Transmission from the Front Panel (simplified)
The settings for the test mode and the data transmission block are normally 2)).
Definitions:
− 7HVW PRGH – With the 21 setting, the "test mode"-bit is transferred for messages
compatible with IEC 60 870–5–103.
− 'DWD6WRS
– With the 21 setting, no messages or measured values are
transferred ("transfer block").
Click on 'HYLFH in the menu bar to reach the commands %ORFN 'DWD
7UDQVPLVVLRQ and 7HVW 0RGH. See Figure 7-40.

²! 
²! 


²! 

ENTER key, enter the password N° 4 (for test and
key. A new window appears with the options
ENTER
and keys to select the desired mode, and press the


%/. '$7$ 75$16


!'DWD6WRS
Control During Operation
key. The 0$,1 0(18 appears.
MENU
key, and then press
7(67 (1$%/(

!7HVW PRGH
key to return to
MENU
2))
2))
ENTER
7-39