Siemens siprotec 7SA6 User Manual page 503

:
From PC with
®
DIGSI 4
7SA6 Manual
C53000-G1176-C133-1
key to return to the 0($685(0(17 sub-menu. Use the
Use the
the 0$,1 0(18.
The measured value groups are found under 0HDVXUHPHQW (Figure 7-2) with a
double click, as shown in Figure 7-21, left.
Figure 7-21 Measurement window in DIGSI
The measured values are categorized into the following groups and subgroups
(maximum scope):
• 3ULPDU\ with
2SHUDWLRQDO YDOXHV SULPDU\
6HQV () YDOXHV SULPDU\
2SHUDWLQJ LPSHGDQFHV SULPDU\
6\QFKURFKHFN PHDVXUHG YDOXHV SULPDU\
• 6HFRQGDU\ with
2SHUDWLRQDO YDOXHV VHFRQGDU\,
6HQV () YDOXHV SULPDU\
2SHUDWLQJ LPSHGDQFHV VHFRQGDU\
• 3HUFHQWDJH with
2SHUDWLRQDO YDOXHV SHUFHQWDJH
referred to the rated operational values;
• 0LQ0D['HPDQG with
'HPDQG
0LQ0D[ 'HPDQG
8,0LQ0D[
3 I 3RZHU )DFWRU 0LQ0D[
• 2WKHU with
7KHUPDO 0HWHU
• 8VHU GHILQHG PHDVXUHG YDOXHV
8VHU GHILQHG FRXQWHU
(QHUJ\
6HW SRLQW YDOXHV RI PHDVXUHG YDOXHV,
i.o.w. only such values that were generated in the configuration (according to 5.2)
and/or with the user definable logic CFC (according to Section 5.3).
If a measured value is not available, then instead of the measured value, 3 dots
appear. If the value is undefined (e.g., cos ϕ, when no current is flowing), then "–––"
Control During Operation
®
4
key to return to
MENU
7-19