Siemens SINAMICS G150 Manual page 1518

4 Faults and alarms
4.2 List of faults and alarms
Reaction upon A: NONE
Acknowl. upon A: NONE
F08010 (N, A) TB: Analog-digital converter
Message value: -
Message class: Hardware / software error (1)
Drive object: All objects
Reaction: Vector: OFF1 (IASC/DCBRK, NONE, OFF2, OFF3, STOP2)
Infeed: NONE (OFF1, OFF2)
Acknowledge: IMMEDIATELY (POWER ON)
Cause: The analog/digital converter on Terminal Board 30 has not supplied any converted data.
Remedy: - check the power supply.
- replace Terminal Board 30.
Reaction upon N: NONE
Acknowl. upon N: NONE
Reaction upon A: NONE
Acknowl. upon A: NONE
F08500 (A) COMM BOARD: Monitoring time configuration expired
Message value: %1
Message class: Communication error to the higher-level control system (9)
Drive object: All objects
Reaction: Vector: OFF1 (OFF2, OFF3)
Infeed: OFF1 (OFF2)
Acknowledge: IMMEDIATELY
Cause: The monitoring time for the configuration has expired.
Fault value (r0949, interpret decimal):
0: The transfer time of the send configuration data has been exceeded.
1: The transfer time of the receive configuration data has been exceeded.
Remedy: Check communications link.
Reaction upon A: NONE
Acknowl. upon A: NONE
F08501 (N, A) PN/COMM BOARD: Setpoint timeout
Message value: -
Message class: Communication error to the higher-level control system (9)
Drive object: All objects
Reaction: Vector: OFF3 (IASC/DCBRK, NONE, OFF1, OFF2, STOP2)
Infeed: OFF1 (OFF2)
Acknowledge: IMMEDIATELY
Cause: The reception of setpoints from the COMM BOARD has been interrupted.
- bus connection interrupted.
- controller switched off.
- controller set into the STOP state.
- COMM BOARD defective.
Remedy: - Restore the bus connection and set the controller to RUN.
- check the set monitoring time if the error persists (p2040).
See also: p8840 (COMM BOARD monitoring time)
Reaction upon N: NONE
Acknowl. upon N: NONE
Reaction upon A: NONE
Acknowl. upon A: NONE
1518
SINAMICS G130/G150
List Manual (LH2), 04/2014, A5E03263479A