Remote Authentication/Directory Service - Fuji Xerox ApeosPort-V C7785 Administrator's Manual

5 Tools
Note
 SMTP Server Name/IP Address
Enter a server name or IP address, and then select [Save]. Up to 128 characters are allowed.
 SMTP Server Port Number
Enter a port number in the range from 1 to 65535.
The default value is 25.
Important • Do not use the numbers assigned to the other ports.
 E-mail Send Authentication
Select one from [Off], [POP before SMTP], or [SMTP AUTH].
Note
 Login Credentials for E-mail Send
Select the login user name when sending e-mails from [Remotely Authenticated User] or
[System]. When [Remotely Authenticated User] is selected and if the machine tries
5
authenticating the remote server before a job startup, the machine performs verification at
the time of transmission with the remotely authenticated user name and password. You can
also select the post-failure behavior of the machine from [Cancel E-mail Send] and [Relogin
using System Data]. If you do not set remote authentication, the machine uses the user ID
and passcode of the machine for authentication.
 SMTP AUTH Login Name
Enter the user name for verification purposes at the SMTP server with up to 64 characters.
 SMTP AUTH Password
Enter the password for verification purposes at the SMTP server. Up to 64 single-byte
characters are allowed.
Note

Remote Authentication/Directory Service

You can make the settings for the remote authentication server and directory service.
Note
Authentication System Setup (ApeosPort Series Models Only)
 Authentication System
Allows you to select the authentication system from [Kerberos (Windows 2000)], [Kerberos
(Solaris)], [LDAP], [SMB], and [Authentication Agent].
After you change the authentication system, folders and job flow sheets used with the
previous authentication system are not deleted automatically. If these folders or job flow
sheets are no longer needed, delete them from the machine. If the same user IDs are also
used on the new authentication system, folders and job flow sheets can be used by the same
users.
218
• For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
• When you make an entry mistake, press the <C> (Clear) button and enter again.
• If [POP before SMTP] is selected, the POP3 settings must be set.
• AUTH GSSAPI (only for Kerberos), AUTH NTLMv2, AUTH NTLMv1, AUTH PLAIN, AUTHLOGIN, or
AUTH CRAM-MD5 can be used as an authentication method.
• If you do not set the password, leave the text boxes blank and select [Save].
• DocuCentre series models can only support the services associated with searches for Address Book
of "LDAP Server/Directory Service Settings (ApeosPort Series Models Only)" (P.219).