Single Fold Position Adjustment - Fuji Xerox ApeosPort-V C7785 Administrator's Manual

16 Appendix
-For C fold, refer to "C Fold Position Adjustment" (P.668).
-For Z fold, refer to"Z Fold Position Adjustment" (P.669)"Z Fold Position Adjustment" (P.669).
-For Z fold half sheet, refer to "Z Fold Half Sheet Position Adjustment" (P.670).

Single Fold Position Adjustment

1
Select [Single Fold], and then select [Change
Settings].
2
Specify [Sheets to be folded], and then select
[Sample Printout].
3
Select the tray in which you loaded paper, and
press the <Start> button.
A sample printout is printed.
4
Select [Close].
5
Check the sample printout, measuring the misaligned amount.
6
Select [Long at Left] or [Long at Right], and enter the value you measured in step 5 in
[Value A Before Adjustment].
7
Select [Adjust].
8
Select [Sample Printout] again.
9
Select the tray in which you loaded paper, and press the <Start> button.
The sample printout is printed.
10
Select [Close].
11
Confirm the result of sample printout.
16
12
Adjust the alignment again if necessary.
13
Select [Save].
14
Select [Close] until the Services Home screen is displayed.
Note
666
• When you configure settings under [System Settings] or [Setup] and then press the <Services Home>
button, the screen directly goes back to the Services Home screen.