Fuji Xerox ApeosPort-V C7785 Administrator's Manual page 63

Loading No.2 Standard Envelope, C4, or the Envelope Whose Width is 182 mm or more
1
Pull out the tray towards you until it stops.
CAUTION
When pulling out the paper tray, do it
slowly. If pulled out with too much
force, the tray can hit and injure your
knees.
Important • While the machine is processing a job, do not pull the tray out that the job uses.
2
Remove any paper loaded in the tray.
3
With the side to be copied or printed on facing
up, load approximately 10 to 30 envelopes in
the tray and align the bottom edge of the
envelopes (not the flap side) in the arrow
direction (1). Pinch the long-side paper guide
and slide it to the desired paper size (2).
4
Likewise, load the remaining envelopes in the
tray and align the bottom edge of the
envelopes (not the flap side) in the arrow
direction (1). Pinch the left short-side paper
guide and slide it to the desired paper size (2).
Important • The number of sheets that can be loaded
5
Push the tray in gently until it stops.
• To prevent paper jams or misloading, do not load envelopes on any paper remaining in the tray.
varies depending on the type of envelopes.
For more information, contact our Customer
Support Center.
• If the envelopes loaded in the tray are 10
sheets or less, the guides apply more pressure
to the envelopes. It may cause distortion of
envelopes, and may cause paper jams.
• When loading envelopes, neatly align all
edges. Also, if the envelopes loaded are
tipped, reduce the number of envelopes
loaded.
• Position the paper guides correctly to match
the paper size. If the positions of the paper
guides are not correct, the paper may not be
fed properly, causing paper jams.
Loading Tab Paper/Postcards/Envelopes
2
63