Fuji Xerox ApeosPort-V C7785 Administrator's Manual page 562

15 Problem Solving
Error Code
033-737 [Cause]
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
033-738
[Cause]
[Remedy] No measure is required.
033-740 [Cause]
[Remedy] No measure is required.
033-741 [Cause]
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
033-742 [Cause]
[Remedy] If this error was caused when using Manual Send, connect the line after storing the
033-743 [Cause]
033-744
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
033-745
033-746
033-747
[Cause]
[Remedy] No measure is required.
033-749 [Cause]
[Remedy] No measure is required.
033-750 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
033-751 [Cause]
[Remedy] No measure is required because the machine will output the report after exiting the
15
562
Cause and Remedy
An error occurred during fax transmission.
Support Center.
Received abnormal JBIG data.
The printing of the received fax document was interrupted.
An error occurred during fax transmission.
Support Center.
An error occurred during fax transmission. This error may occur if the remaining
capacity of the machine's memory is 10% or less and Manual Send is used.
document, and then send. If the error still is not resolved, delete unnecessary data from
the hard disk to free up disk space, and execute the operation again.
If the error persists, contact our Customer Support Center.
An error occurred during fax transmission.
on the machine power. Try again. If the error still is not resolved, contact our Customer
Support Center.
The job is temporarily suspended.
The machine will automatically recover and print the document.
An error occurred during fax transmission.
on the machine power. Try again. If the error still is not resolved, contact our Customer
Support Center.
An activity report output occurred during the printer lockout duration. Outputting the
activity report was suspended because the machine was in the Sleep mode.
Sleep mode.