Replacing Toner Cartridges - Fuji Xerox ApeosPort-V C7785 Administrator's Manual

3 Maintenance
Replacing the Staple Scrap Container for Finisher D2-P with Booklet Maker..................................................................91

Replacing Toner Cartridges

The following messages appear on the touch screen depending on the amount of toner
remaining. Replace the toner cartridge according to the message.
Yellow Toner [Y] Cartridge
needs to be replaced soon.
Yellow Toner [Y] Cartridge
needs to be replaced.
3
*1 : The messages in the above table apply to Yellow Toner. "Yellow Toner [Y]" shown in the messages vary depending on the
*2 : The remaining page yield for copy/print jobs is applicable when A4 paper LEF (
 Never use a vacuum cleaner for spilled toner and residual toner in this product,
toner cartridge or toner bottle. It may catch fire by electric sparks inside a
vacuum cleaner and cause explosion. Use a broom or a wet cloth to wipe off the
spills. If you spill a large volume of toner, contact your local Fuji Xerox
representative.
 Never throw a toner cartridge into an open flame. Remaining toner in the
cartridge may catch fire and cause burn injuries or explosion. If you have a used
toner cartridge no longer needed, contact your local Fuji Xerox representative
for its disposal.
Important • When you replace a toner cartridge, toner may spill and soil the floor. We recommend laying paper
Note
74
*1
Message
A toner cartridge does not need to be replaced. Prepare a toner
cartridge indicated by the message.
Note
Replace the toner cartridge with a new one.
color and number of the applicable toner.
depending on the conditions such as the content printed, dot coverage (area coverage), paper size, paper type, copy/print
density, output image type, and the machine operating environment.
WARNING
on the floor beforehand.
• The use of toner cartridges not recommended by Fuji Xerox may degrade image quality and
performance. Use only toner cartridges recommended by Fuji Xerox.
• When the remaining amount of toner is low, the machine may stop printing and display a message.
If this occurs, replace the toner cartridge to resume copying or printing.
• Replace toner cartridges while the machine is on.
• When the machine is in the Power Saver mode, exit the Power Saver mode by pressing the <Power
Saver> button and the <Machine Status> button on the control panel before you replace the toner
cartridge.
• When replacing the toner cartridge, press the <Machine Status> button and check the current status
for the toner cartridge even when the control panel is lit.
• After the message "The Toner Cartridge needs to be replaced." appears on the touch screen, copy or
print density may be reduced slightly.
• If a partially used toner cartridge is used, a message appears and the number of pages that you can
copy or print displayed on the screen may differ considerably.
• Monochrome copying and printing are available even when color toners are run out. In this case,
only plain paper can be used.
Solution
• The following shows the remaining number of pages that can
be copied or printed after the message appears.
- Black: Approximately 1,800 pages
- Yellow, Cyan, Magenta: Approximately 1,200 pages
) is used. The value is an estimate and varies
*2
*2