Remote Authentication/Directory Service - Fuji Xerox ApeosPort-IV C5575 Administration Manual

5 Tools
Login Credentials for E-mail Send
Select the login user name when sending e-mails from [Remotely Authenticated User] and
[System]. When [Remotely Authenticated User] is selected and if the machine tries
authenticating the remote server before a job startup, the machine performs verification at
the time of transmission with the remotely authenticated user name and password. You can
also select the post-failure behavior of the machine from [Cancel E-mail Send] and [Relogin
using System Data]. If you do not set remote authentication, the machine uses the user ID
and passcode of the machine for authentication.
SMTP AUTH Login Name
Enter the user name for verification purposes at the SMTP server with up to 64 characters.
SMTP AUTH Password
Enter the password for verification purposes at the SMTP server. Up to 64 single-byte
characters are allowed.
Note

Remote Authentication/Directory Service

You can make the settings for the remote authentication server and directory service.
Note
5
Authentication System Setup (ApeosPort Series Models Only)
Authentication System
Allows you to select the authentication system from [Kerberos (Windows 2000)], [Kerberos
(Solaris)], [LDAP], [SMB], and [Authentication Agent].
After you change the authentication system, personal folders and personal sheets used with
the previous authentication system are not deleted automatically. If these folders or job
flow sheets are no longer needed, delete them from the machine. If the same user IDs are
also used on the new authentication system, personal folders and personal job flow sheets
can be used by the same users.
Server Response Time-Out
Set the server time-out response between 1 and 75 seconds in 1 second increments.
Search Time-Out
Set the user information search time-out between 1 and 120 seconds in 1 second
increments.
Kerberos Server Settings (ApeosPort Series Models Only)
Configure the Kerberos Servers 1 to 5.
The settings in [Kerberos Server 1 (Default)] will be the default settings for authentication.
Primary Server Name/Address
Enter the primary server name or IP address.
Note
212
• If you do not set the password, leave the text boxes blank and select [Save].
• DocuCentre series can only support the services associated with searches for Address Book of "LDAP
Server/Directory Service Settings (ApeosPort Series Models Only)" (P.213).
• For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.