Machine Trouble - Fuji Xerox ApeosPort-V C7785 Administrator's Manual

Machine Trouble

Before you conclude that the machine is defective, check the machine status again.
Symptom
The machine is
not powered on.
The <Error>
indicator is
blinking.
The <Error>
indicator is lit.
The touch screen
is too dark.
Text displayed on
the tough screen
is garbled.
Cause
Is the main power and power
switched on?
Is the power cord plugged
into the power outlet?
Is the power cord
disconnected from the
machine?
Does the AC outlet supply
power properly?
The system of the machine or
the components installed
may have a trouble.
Is paper or a document
jammed?
Is the front cover or top cover
open?
Is a message displayed on the
touch screen prompting you
to replace the consumables?
Is the <Power Saver> button
lit?
Is the screen brightness too
low?
Extended functions may not
be enabled.
Remedy
Switch the main power and power on.
Refer to "2 Product Overview" in the User Guide.
Switch the main power and power off, and
then firmly plug the power cord into the
connector of the machine and power outlet.
Then switch the main power and power on.
Refer to "2 Product Overview" in the User Guide.
Connect another appliance to the outlet to
verify the power supply.
Refer to "1 Before Using the Machine" in the User Guide.
Switch the main power and power off and
then on. If the error still is not resolved,
contact our Customer Support Center.
Remove the jammed paper or document.
If paper is jammed, refer to "Paper Jams" (P.589), and a
document is jammed, refer to "Document Jams"
(P.624).
Solve the problem by following the message
displayed.
Replace the consumables indicated in the
message.
Refer to "Replacing Consumables" (P.72).
The machine is in the Power Saver mode.
Press the <Power Saver> button on the
control panel to exit the Power Saver mode.
Refer to "2 Product Overview" in the User Guide.
Adjust the screen brightness on the [Screen
Brightness] screen.
Refer to "Adjusting Screen Brightness" (P.33).
Enable the extended functions.
Refer to "Passcode Setting for Extended Function"
(P.776).

Machine Trouble

15
437