Staple Cartridge Taken Off From Unit For The Finisher D2-P With Booklet Maker - Fuji Xerox ApeosPort-V C7785 Administrator's Manual

15 Problem Solving
Staple Cartridge Taken Off from Unit for the Finisher D2-P with
Booklet Maker
The following describes how to set the staple cartridge to its unit when it has been attached
incorrectly or taken off from its unit accidentally.
Be careful when removing jammed staples.
1
Open the staple cartridge cover as shown in the
figure, and remove the jammed staple.
2
See a lever on the rear side of the unit.
3
Move the lever in the direction of the arrow
shown in the figure.
Important • Be careful when removing jammed staples to
4
Turn the unit upside holding the lever, and then
take off the staple cartridge from its unit.
15
634
CAUTION
avoid hurting your fingers and nails.