Fuji Xerox ApeosPort-V C7785 Administrator's Manual page 227

Set the IKE authentication method. Select from [Authenticate by Preshared Key] and
[Authenticate by Digital Signature].
 Preshared Key
Enter a preshared key.
This setting is valid when [IKE Authentication Method] is set to [Authenticate by
Preshared Key].
 Device Certificate
Select a certificate for IPsec communications.
Set a certificate when [IKE Authentication Method] is set to [Authenticate by Digital
Signature]. A self-signed certificate created by CentreWare Internet Services cannot be
used.
For more information on a certificate, refer to "Types of Certificate" (P.390).
 IPsec Communication
Select whether or not to enable IPsec communications.
 IKE SA Life Time
Specify IKE SA lifetime from 5 to 28800 minutes in 1 minute increments.
Note
 IPsec SA Life Time
Specify IPsec SA lifetime from 300 to 172800 seconds in 1 second increments.
Note
DH Group

Set DH group. Select from [G1] and [G2].
 PFS Settings
Select whether or not to enable PFS.
 Destination IPv4 Address
Set the IPv4 address of the destination.
When entering an IP address, enter the address in the format "xxx.xxx.xxx.xxx", where
"xxx" is a numeric value from 0 to 255.
 Destination IPv6 Address
Set the IPv6 address of the destination.
When entering an IP address, enter the address in the format
"xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a hexadecimal value.
 Communicate with Non-IPsec Devices
Select whether or not to communicate with non-IPsec devices.
IEEE 802.1X Settings / IEEE 802.1X Settings (Ethernet 1), IEEE 802.1X Settings (Ethernet 2)
Note
• The value must be greater than the value set in [IPsec SA Life Time].
• The value must be smaller than the value set in [IKE SA Life Time].
• When the [TCP/IP - Network Settings (Ethernet 1)] and [TCP/IP - Network Settings (Ethernet 2)]
settings are configured, you can configure individual IEEE802.1X settings for each Ethernet
interface.
• The title of this setting item differs depending on the Ethernet interface configuration: When single
Ethernet interface is used, [IEEE 802.1X Settings] is displayed. When two Ethernet interfaces are
used, [IEEE 802.1X Settings (Ethernet 1)] and [IEEE 802.1X Settings (Ethernet 2)] are displayed.
• When any interface names are specified in [Ethernet1 - Network Name] and [Ethernet2 - Network
Name], the specified names are displayed instead of "Ethernet1" and "Ethernet2" of [IEEE 802.1X
Settings (Ethernet 1)] and [IEEE 802.1X Settings (Ethernet 2)] respectively.
Connectivity & Network Setup
227
5