Fuji Xerox ApeosPort-V C7785 Administrator's Manual page 542

15 Problem Solving
Error Code
027-446 [Cause]
[Remedy] Change the [Manually Configured IPv6 Address] on the machine, or the IP address of
027-447
[Cause]
[Remedy] Change the [Link-local Address] for IPv6 on the machine, or the IP address of IPv6 on
027-452 [Cause]
[Remedy] Change the IP address of IPv4 set on the machine or the IP address of IPv4 on the
027-500 [Cause]
[Remedy] Specify the SMTP server name correctly or specify the server by using its IP address.
027-501 [Cause]
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
027-502 [Cause]
[Remedy] Confirm whether the user name and password used in the POP3 server are correct on
027-503
[Cause]
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
027-504 [Cause]
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
027-513 [Cause]
[Remedy] Consult your system administrator for settings.
027-514 [Cause]
[Remedy] Check the following conditions:
027-515 [Cause]
[Remedy] Take the following measures:
15
542
Cause and Remedy
The IP address of IPv6 set manually already exists.
IPv6 on the network device, to remove the duplication of addresses.
The IP address of IPv6 already exists.
the network device, to remove the duplication of addresses.
IP address of IPv4 already exists.
network device.
Unable to connect to the SMTP server.
A POP server error occurred.
Support Center.
Failed to log into the POP3 server when using the POP3 protocol.
CentreWare Internet Services.
A POP server error occurred.
Support Center.
An SMTP server error occurred.
Support Center.
The machine failed to transfer data using SMB of the Scan to PC service because access
to the SMB server was not permitted.
The machine failed to transfer data using SMB of the Scan to PC service because an
error has been occurred between the SMB server and the DNS server.

The SMB server is connected to the DNS server.

The SMB server name is registered on the DNS server.
The machine failed to transfer data using SMB of the Scan to PC service because an
error has been occurred.

Set the DNS server address.

Set the target SMB server address using IP address.