Protocol Settings - Fuji Xerox ApeosPort-V C7785 Administrator's Manual

5 Tools
Important • We recommend you to enable [HTTP - SSL / TLS Communication] under [SSL / TLS Settings] when
Note
 Port Number
Enter a port number for WebDAV from 1 to 65535.
The default value is 80.
Important • Do not use a number that is the same as a port number of another port. However, you can use the
 Operation Time-Out
You can enter an operation time-out period between 1 and 65535 seconds in 1 second
increments.
ThinPrint
 Port Status
You can use the machine for print in the ThinPrint print environment. The machine
decompresses and prints the compressed print data sent from the print server.
Select [Enabled] when you use ThinPrint
5
 Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
Important • Do not use any numbers assigned to the other ports.
Note

Protocol Settings

Set the parameters required for communications. [Protocol Settings] consists of the
following categories:
Ethernet Settings

 TCP/IP - Common Settings
 TCP/IP - Network Settings
Note
Also on [Ping Connection Test], you can check whether or not the machine can be properly
connected to a network with the configured condition.
Ethernet Settings
Configure the Ethernet settings.
 Ethernet1 - Network Name, Ethernet 2 - Network Name
When two Ethernet interfaces are used, specify the names respectively.
Note
206
you use WebDAV. This is an effectual way to avoid password leaking.
• You cannot select [Port Number] and [Operation Time-Out], if WebDAV port is disabled.
To configure [Port Number] and [Operation Time-Out], enable port status and reboot the machine,
and then configure [Port Number] and [Operation Time-Out].
same port number for a port that uses HTTP (PP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).
• ThinPrint is available when the communication protocol uses IPv4.
• The maximum of three connections are possible at a time.
• To configure each category, select the corresponding item and then select [Change Settings].
• This item is displayed only when Secondary Ethernet (optional) is installed on the machine.
®
.