Fuji Xerox ApeosPort-V C7785 Administrator's Manual page 582

15 Problem Solving
Error Code
117-312 [Cause]
117-313
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
117-314
117-315
117-316
117-317
117-318
117-319
117-320
117-321
117-322
117-323
117-324
117-325
117-326
117-327
117-330
117-331
117-332
117-333
117-334
117-342
117-343 [Cause]
[Remedy] For 1), set other than [Transfer Per Job Basis] for [Log to Transfer].
117-347 [Cause]
[Remedy] Contact our Customer Support Center.
117-348
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
118-310
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
15
118-311
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
121-310 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
582
Cause and Remedy
An error occurred in the machine.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
Probable causes are follows.
1)When [Image Log Control] on Tools is invalid and [Enabled] is set for [Log Transfer]
under [Transfer Image Log], [Transfer Per Job Basis] is set for [Logs to Transfer].
2)When [Transfer Image Log] is invalid (the hard disk is not installed), [Log Transfer] is
set to [Enabled].
For 2), install the hard disk to the machine, or set [Pause] for [Logs To Transfer].
The life of the component which cannot be replaced is expired. The machine itself needs
to be replaced.
The unformatted SD card used in the other machine is installed.
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
An error occurred in the machine.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
An error occurred during software processing.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
An error occurred in the machine.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.