Fuji Xerox ApeosPort-V C7785 Administrator's Manual page 541

Error Code
026-729 [Cause] Probable causes are as follows:
1)An error occurred during WSD communications.
2)Application other than [Windows Fax and Scan] was used to scan a document on the
[Remedy] For 1), check whether the network cable is correctly connected or check the amount of
available memory of the destination device.
For 2), Use [Windows Fax and Scan] to scan. If using another application, set the
document on the document glass.
Note • WSD stands for Web Services on Devices.
026-730 [Cause] The size of paper loaded in the specified tray is unknown.
[Remedy] Check whether the paper guides are correctly positioned in the tray, and then try again.
026-735 [Cause] When authentication succeeds, all jobs are canceled because there is a pending job.
[Remedy] No measure is required.
026-736 [Cause] An internal error occurred while sending the scanned document to the HTTP server.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
026-737 [Cause] Unable to send the scanned document to the HTTP server because a network error
occurred.
[Remedy] Consult your network administrator whether the network or the server have any
problem.
026-738 [Cause] The machine failed to send scanned document data to the HTTP server because Web
application is closed during it.
[Remedy] Execute the operation again.
026-739
[Cause] When authentication succeeds, due to that there are pending scan job and fax job,
either of these jobs is canceled.
[Remedy] No measure is required.
027-400 [Cause] Communications with the machine failed.
[Remedy] If other messages are displayed, confirm their content. If the control panel is being
operated, terminate the operation. If remote access is being executed, wait until it
completes. If the error still is not resolved, switch off the machine power, make sure that
the touch screen is blank, and then switch on the machine power.
If the problem persists, contact our Customer Support Center.
027-442 [Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Auto Stateless Address 1] for IPv6 on the machine, or the IP address of
IPv6 on the network device, to remove the duplication of addresses.
027-443
[Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Auto Stateless Address 2] for IPv6 on the machine, or the IP address of
IPv6 on the network device, to remove the duplication of addresses.
027-444 [Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Auto Stateless Address 3] for IPv6 on the machine, or the IP address of
IPv6 on the network device, to remove the duplication of addresses.
027-445 [Cause] IP address for IPv6 set manually is incorrect.
[Remedy] Set the IP address correctly.
Cause and Remedy
scanner (WSD).
Error Code
15
541