Finisher Adjustment; Software Upgrade - Fuji Xerox ApeosPort-V C7785 Administrator's Manual

 Trays 1 to 6
Assign the type to a tray.

Finisher Adjustment

Note
 Hole Punch Tool
Specify the punch unit to be used (Punch Unit 2/4H CD1 or Punch Unit US 2/3H CD1).
 Adjust Booklet Fold Position
Set the booklet fold position for paper smaller or longer than B4.
 Adjust Fold Position
You can adjust the fold position for each paper type and can set up to 10 adjustment types.
Also, you can assign the type to each tray.
 Fold Position Type Setup
Adjust the position for Single Fold, Booklet, C Fold, Z Fold, and Z Fold Half Sheet.
For more information on setting procedures, refer to "Fold Position Adjustment" (P.665).
 Trays 1 to 4, and 6 (optional)
Assign an adjustment type to each tray.
 Fold Assisting Crease
Set the number of additional folding lines between the specified fold line to prevent the
output of the folded booklet from opening.
Select from [1 Crease per Side], [2 Creases per Side], [3 Creases per Side], and [No Crease].
Note
Adjust Image Transfer
You can adjust the transfer output value when image transfer is poor.
For more formation on adjusting image transfer, refer to "Adjust Image Transfer" (P.672).

Software Upgrade

When EP system via the Internet is used, this feature is used to upgrade the software for EP
system when the version upgrade is required.
You can specify when to start the software upgrade.
Important • After the downloading is finished, the machine automatically restarts and upgrades the software.
Note
For information on EP system, refer to "EP System" (P.783).
1
Select [Software Upgrade].
• To use this feature, an optional component is required for some models. For more information,
contact our Customer Support Center.
• The fewer the folding lines, the stronger the formation of creases. The more the number of folding
lines, the slower the booklet creation speed.
• The booklet may open depending on the paper size and paper type even though the Fold Assisting
Crease feature is used.
After the machine restarts again and the Services Home screen is displayed, the software upgrade is
completed.
• EP system may not be available in some regions. For more information, contact our Customer
Support Center.
• To use this feature, a dedicated contract is needed in addition to a use of the EP system service. For
more information, contact our Customer Support Center.
Common Service Settings
167
5