Installation When Using Usb Port; Step 1 Preparations; Step 2 Configuration On The Machine - Fuji Xerox ApeosPort-V C7785 Administrator's Manual

7 Printer Environment Settings

Installation When Using USB Port

This section describes how to install the machine using a USB interface.

Step 1 Preparations..................................................................................................................................................................... 332

Step 2 Configuration on the Machine .................................................................................................................................... 332

Step 3 Configuration on the Computer.................................................................................................................................. 333
CentreWare Internet Services Setting Items ........................................................................................................................ 333
Step 1 Preparations
The following items are required to connect the machine to a computer via a USB interface.
 USB cable
 Media (Software/Product Manual) provided with the machine
Step 2 Configuration on the Machine
The following describes the configuration procedures to use a USB interface on the
machine.
Note
1
Display the [Tools] screen.
7
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note
3) Select [Tools] on the Services Home screen.
2
Enable the USB port on the machine.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [USB], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
3
Configure [Print Mode] or [Auto Eject Time] as necessary.
For information on the setting items, refer to "USB" (P.201).
4
Select [Close] repeatedly until the [Tools] screen is displayed.
5
Select [Close].
Note
6
Print a configuration report to confirm that the USB port is enabled.
332
• To print binary data using a USB interface, set [Adobe Communication Protocol] to [RAW]. For more
information, refer to "USB" (P.201).
• You can configure the settings using CentreWare Internet Services. For items that can be configured
using CentreWare Internet Services, "CentreWare Internet Services Setting Items" (P.333).
• The default user ID is "11111".
• The default passcode is "x-admin".
• Rebooting the machine may be required depending on the settings. When a message displayed on
the screen, follow the message and reboot the machine.