Loading Envelopes - Fuji Xerox ApeosPort-V C7785 Administrator's Manual

2 Paper and Other Media
6
Likewise, load the remaining postcards and
align the edges of the postcards in the arrow
direction (1). Pinch the left short-side paper
guide and slide it to the desired paper size (2).
Important • Do not load paper exceeding the maximum
7
Push the tray in gently until it stops.
Note
2

Loading Envelopes

Envelopes can be loaded in Tray 5 (Bypass) and Tray 6 (HCF B1-S).
The following size envelopes can be loaded.
 Standard Size
- No.3 standard envelopes
- No.2 standard envelopes
- C5
- C4
 Non-Standard Size
- Width (Y) 100 - 330 mm, length (X) 148 - 488 mm
When the envelope width is less than 182 mm, be sure to attach the Post Card Kit to Tray 6
(HCF B1-S).
For how to load an envelope in Tray 5 (Bypass), refer to "Loading Paper in Tray 5 (Bypass)" (P.51).
Important • The number of sheets that can be loaded varies depending on the type of the envelope. For more
Note
62
fill line. It may cause paper jams or machine
malfunctions.
• If the number of sheets is 100 or less, the
paper guides touch too tightly against the
paper, causing paper to deform and resulting
in paper jams.
• Position the guides correctly to match the
paper size. Otherwise, the paper may not be
fed properly and cause paper jams.
• When removing the Post Card Kit from the
tray, completely loosen the screw before
removing the kit. Place the removed Post
Card Kit back to its original location (1). Then,
tighten the screw for storing (2).
(120 x 235 mm)
(240 x 332 mm)
(162 x 229 mm)
(229 x 324 mm)
information, contact our Customer Support Center or our customer engineers.
• Carefully fan the paper before loading it in a tray. Otherwise, paper jams may occur or multiple
sheets may be fed to the machine simultaneously.
• When loading envelopes, be sure to adjust the position of the weight switch buttons. For more
information, refer to "About Weight Switch Buttons" (P.66).