Fuji Xerox ApeosPort-V C7785 Administrator's Manual page 480

15 Problem Solving
Error Code
003-702 [Cause]
[Remedy] Specify the same Reduce/Enlarge ratio for both sides.
003-703
[Cause]
[Remedy] Place the Calibration Chart properly.
003-704 [Cause]
[Remedy] Execute the calibration again. If the error is not still resolved, contact our Customer
003-705
[Cause]
[Remedy] Cancel copying, and perform the operation for copying again.
003-750
[Cause]
[Remedy] Check the 2 Sided Book Copying settings.
Refer to "3 Copy" > "Layout Adjustment" in the User Guide.
003-751 [Cause]
[Remedy] Increase the resolution or scan area.
003-752 [Cause]
[Remedy] Set [Resolution] to [400dpi] or lower, and try scanning again.
003-753 [Cause]
[Remedy] Set [Resolution] to [200dpi], and scan the document again.
003-754
[Cause]
003-755
[Remedy] Execute the job again.
003-756 [Cause]
[Remedy] Check whether the document is blank or whether the side of the document to be faxed
003-757
[Cause]
[Remedy] Set [Resolution] to [300dpi] or lower, and scan the document again.
003-760 [Cause]
[Remedy] Confirm the selected options.
003-761 [Cause]
[Remedy] Change the paper size for the tray, or change the [Paper Type Priority] settings.
003-763 [Cause]
15
[Remedy] Place the Calibration Chart correctly on the document glass.
Refer to "Executing Calibration" (P.96).
003-780 [Cause]
[Remedy] Reduce the resolution or the ratio for [Reduce/Enlarge] to decrease the data size, or split
480
Cause and Remedy
You tried to copy sides 1 and 2 of a document simultaneously specifying different
Reduce/Enlarge ratio for each side.
The Calibration Chart is not detected correctly.
An error is found in the calibration pattern read, and the machine may be out of order.
Support Center.
Copying is started before the machine exits the Power Saver mode and detects the
change for the tray size, when the paper size set in the tray that has been changed
during the Power Saver mode.
Unable to store any documents using the 2 Sided Book Copying feature.
Unable to process the document because the specified scan area is too small.
A mix sized document was to be scanned at 600 dpi in Color/2 sided.
A mix sized document was to be scanned at high resolution, 2 sided.
An error occurred in the document feeder.
The faxed document is completely blank.
is loaded correctly.
A mix sized document was to be scanned at high resolution, 2 sided.
An incompatible combination of feature is specified for document scan conditions.
The paper size of the tray selected for auto tray differs from the paper size of the tray
selected for Auto Paper selection.
An error occurred when reading the Calibration Chart.
Failed to compress the scanned document.
the data to send it separately.