Protocol Settings - Fuji Xerox apeosport-iv C5570 Administrator's Manual

5 Tools
Port Number
Enter a port number for the Internet Services from 1 to 65535.
The default value is 80.
Important • Do not use the numbers assigned to the other ports.
Note
SOAP
Port Status
Select [Enabled] when you use an application program such as EasyOperator.
Port Number
Enter a port number for SOAP from 1 to 65535.
The default value is 80.
Important • Do not use the numbers assigned to the other ports.
WebDAV
Port Status
Select [Enabled] when you use an application program such as EasyOperator and Network
Scanner Utility3 to access folders in the machine.
Note
5
Port Number
Enter a port number for WebDAV from 1 to 65535.
The default value is 80.
Important • Do not use the numbers assigned to the other ports.
Operation Time-Out
You can enter a operation time-out period between 1 and 65535 seconds in 1 second
increments.
ThinPrint
Port Status
You can use the machine for print in the ThinPrint.print environment. The machine
decompresses and prints the compressed print data sent from the print server.
Select [Enabled] when you use ThinPrint.
Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
Important • Do not use any numbers assigned to the other ports.
Note

Protocol Settings

Set the parameters required for communications. In [Protocol Settings], you can set the
following items.
Ethernet Rated Speed
Set the communication speed for the Ethernet interface.
178
• You cannot select [Port Number], if HTTP port is disabled.
To configure [Port Number], enable port status and reboot the machine, and then configure
[Port Number].
• You cannot select [Port Number] and [Operation Time-Out], if WebDAV port is disabled.
To configure [Port Number] and [Operation Time-Out], enable port status and reboot the
machine, and then configure [Port Number] and [Operation Time-Out].
• ThinPrint is available when the communication protocol uses IPv4.
• The maximum of three connections are possible at a time.