Removing Master-Cylinder Housing; Installing Master-Cylinder Housing - Arctic Cat EL TIGRE 1980 Service Manual

I
'
I •
6. Apply glue (Scotch-Grip Plastic Adhesive
1099
or equivalent) to the bore of the han-
dle grip and using a rubber hammer, drive
the handle grip into position.
7.
Place the handlebar pad into position and
secure with cab le ties.
Fb.}
II
M
t
ut1®rM@v1ng as er-
1~w~aITTlder
Housing
1. Remove the cable ties securing the
handlebar pad; then on the
5000,
remove
th e pad and on the
6000,
rol
I
the pad back
expos in g control wires, cable, and hose.
2.
Di sco nnect wiring harness from the hous-
•
Ing.
3. Rem ove the two bolts and lock nuts secur-
ing caliper housing. Account for a washer.
Fig. 6·5
....__
_ _
,/
....
•• y
Fig. 6·6
•
•
8171
NOTE: The housing will force the
handlebar grip off.
Installing Master-
Cylinder Housing
1. Slide housing onto the handlebar; then
secure with a tapping screw. ·
Fig. 6·7
8111
8 388 2. Install the caliper housing and secure with
4. Remove the tapping screw securing hous-
ing to handlebar; then slide housing off
handlebar.
•
the two bolts and lock nuts and washer.
NOTrE:
an
the 6000, make sure tfie radiator
bracket Is secured by the front bolt.
•
•
11