Rs232C Settings Screen Program Notes - Sam4s SPS-300 Series Operator's And Programming Manual

You must
allocate at
least 1 EJ
Line.
You must
allocate at
least 1 check
for each clerk
allocated.
SAM4s SPS-300 Operator's & Programming Manual v1.34
2. The total available memory is displayed on the first line of the screen (TTL
AVAIL). The total memory currently allocated is displayed on the second line of
the screen (TTL USED). The TTL USED field is updated when you complete a
change and press CASH.
Starting at the PLU's field, enter the quantity of each memory field. Press
CASH after each entry, and the cursor will move to the next field. Page 2 of
Memory Allocation will display after the # OF GROUP TOTALS field is set:
NOTE: You must allocate at least one line of electronic journal (EJ) and at least
one check for each clerk allocated.
MEMORY ALLOCATION
TTL AVAIL :
TTL USED :
# EJ LINES
# CHECKS
Y=HARD/N=SOFT CHK
# LINES/SFT CHK
3. Continue filling each field until complete. Press CASH after setting the last
field, "# LINES/SOFT CH". The screen will display "ARE YOU SURE ?". N
(No) will display as the default answer to the question. If you wish to implement
the new allocation you have entered, press the YES/NO key, and then press
CASH.
4. The message "PLEASE WAIT . . . . " displays until the printer prints either:
"MEMORY ALLOCATION OK !" or "MEMORY ALLOCATION SIZE OVER"
if you attempt to allocate features requiring more memory than is available.
5. The SERVICE MODE menu screen displays when memory allocation
programming is completed.
1855488
314865
1000

10
N
50
S-Mode Programming • 125