Sam4s SPS-300 Series Operator's And Programming Manual page 146

Clear Current Batch
The clear batch command erases all the current batch transactions from the DataTran memory
even if they have not been settled. A LOCAL TRANSACTION INQUIRY should be printed
prior to clearing the batch. This will ensure that the operator has the transaction detail to re-
enter if required.
This operation should only be done under the direction of DATACAP.
146 • S-Mode Programming
10. Press OK Button. The download takes about 3 minutes. At the PC, the
scroll bar will track the progress of the download. At the ECR, the display
will flash (Current program is being erased), after a few seconds, the display
will continue to flash, but at a slower rate. This continues for about 3
minutes while the new program is being loaded.
11. When complete, the message Completed displays at the PC. Click OK and
the Download program will close. At the ECR, when the load is complete, a
rapid beep-beep-beep will be heard, and the display will flash rapidly. Turn
the power switch to OFF, the program update is complete.
12. Disconnect the PC cable.
13. Perform a memory all clear on the ECR. The ECR is now ready to program
or to load a previously saved end-user program.
SAM4s SPS-300 Operator's & Programming Manual v1.34