Balancing Formulas - Sam4s SPS-300 Series Operator's And Programming Manual

Machine No.
The machine number is printed on the register receipt. Program a machine number so that
any receipt can be identified with the store or register where the transaction took place. The
machine number may be a different number than the IRC register number programmed in
IRC programming (see "IRC Options" in the "Service Mode Programming" chapter.)
Training Mode Password
If you wish to use training mode, you must program a password that you will use to enter
training mode. The password may be up to 4 digits long, however, if you choose to use a
password less that for digits, you must enter preceding zeros to complete a 4 digit entry. For
example, if you program the password to be "77", you must type "0077" when entering
training.
262 • Program Mode Programming
1. From the PGM control lock position menu, press 00 for MORE. The
PROGRAM MODE page 2 screen displays. Press PAGE DOWN to view the
remainder of the page 2 program options.
2. From the PROGRAM MODE page 2 screen, press 7 for MACHINE NO. The
MACHINE # PROG. screen displays:
MACHINE # PROGRAM
MACHINE #
3. Type the machine number, up to 5 digits, press CASH.
1. From the PGM control lock position menu, press 00 for MORE. The
PROGRAM MODE page 2 screen displays. Press PAGE DOWN to view the
remainder of the page 2 program options.
2. From the PROGRAM MODE page 2 screen, press 9 for TRAINING MODE
P/W. The TRAINING MODE P/W screen displays:
TRAINING MODE PASSWORD
PASSWORD :
SAM4s SPS-300 Operator's & Programming Manual v1.34
0

0
