Macro - Sam4s SPS-300 Series Operator's And Programming Manual

Postamble
The postamble is a programming message of up to six lines of 32 characters that appears at
the bottom of each receipt and/or guest check.
SAM4s SPS-300 Operator's & Programming Manual v1.34
3. Using the same procedure, continue programming each line as necessary. Press
CLEAR at any time to exit. After programming the third line, the fourth, fifth,
and sixth lines display:
LINE 4 :
LINE 5 :
LINE 6 :
4. When the last line has been entered, press CASH to accept the line and return to
the LOGO DESC. PROGRAM screen.
1. From the LOGO DESC. PROGRAM screen, press 0 to display the
POSTAMBLE screen:
LINE 1 :
LINE 2 :
LINE 3 :
2. Using the alpha numeric keyboard overlay (SPS-320/SPS-340, type the
descriptor. For the SPS-345 use the descriptor code method (see page 117.)
Each line can be up to 32 characters. If you make a mistake, press the
BACKSPACE key (on the alpha overlay or enter the backspace code 97 if you
are using the descriptor code method) to erase the previous character. After you
have completed typing the first line, press CASH to accept the new line and
advance to the second line, or press CLEAR to return to the LOGO DESC.
PROGRAM screen without making any changes.
PREAMBLE
POSTAMBLE




Program Mode Programming • 243