Editing an Existing Macro
SAM4s SPS-300 Operator's & Programming Manual v1.34
4. Continue to enter keystrokes until the macro is complete. Press CLEAR to end
the macro recording and return to the MACRO PROGRAM screen. If you wish
to add a function to a macro that is not located on the keyboard, or if you wish to
include the CLEAR, Y/N, PAGE UP, or PAGE DOWN function to a macro
string (these keys are used for editing purposes inside this program), press PAGE
DOWN to display a key code list:
FUNCTION
-------------------------------
NLU#1 - NLU#150(1-150)
ONE
TWO
THREE
FOUR
FIVE
5. With the key code list displayed, press PAGE DOWN and PAGE UP to find the
function you wish to add to the macro. Type the numeric code number press
CASH. The function is added to the macro.
1. After selecting a macro to program the screen displays the keystrokes currently
programmed.
1. ONE
2. TWO
3. THREE
4. FOUR
5.
6.
7.
8.
2. Press the YES/NO key to advance the cursor to the line you wish to edit.
3. With the cursor pointing at a line, press (or select) the new function you wish to
place in the macro sequence.
4. If you wish to remove a key stroke from a macro, replace the current function
with the INACTIVE function by pressing the PAGE DOWN to display a key
code list, then enter
4 4 5.
KEYCODE
301
302
303
304
305
Program Mode Programming • 261