Getting Started; Quick Start Steps; Unpacking - Sam4s SPS-300 Series Operator's And Programming Manual

Initial Clear
CAUTION: Do not share this information with unauthorized users. Distribute the
PGM Mode key only to those you may want to perform this function.
The initial clear function allows you to exit any register activity and return to a beginning or
cleared state. Any transaction that is in progress will be exited and totals for that transaction
will not be updated.
Here are some reasons you may want to perform an initial clear:



Perform this procedure only as necessary. Contact your SAM4s dealer first if you have
questions about operating or programming your SAM4s SPS-300.
To Perform an Initial Clear:
1. Turn the power switch located on the right side of the register to the OFF position.
2. Turn the control lock to the PGM position.
3. Press and hold the key position where the SUBTOTAL key is located on the default
4. While continuing to hold the SUBTOTAL key, turn the power switch to the ON
5. The message "INITIAL CLEAR OK!" prints when the initial clear is complete. To
SAM4s SPS-300 Operator's & Programming Manual v1.34
The register is in an unknown state, and you wish to exit the current program or
transaction without following normal procedures.
You have performed a function that includes a compulsory activity and you wish to
bypass the compulsion.
An initial clear may be necessary as part of servicing, or troubleshooting.
keyboard layout.
position. When the "Initial Clear Service" message displays release the SUBTOTAL
key.
resume operations, you will need to sign on a clerk.
SPS-320 and SPS-340
Press and hold the
SUBTL key position
during power-up in
PGM mode.
SPS-345
Press and hold the
SUBTOTAL key
position during
power-up in PGM
mode.
Introduction • 25