Sam4s SPS-300 Series Operator's And Programming Manual page 177

System Options - Reference Information
Option
BEEPER ACTIVE
RESERVED
CLERK ENTRY
0:PUSH 1:CODE
CLERK ASSIGNED
WHEN CLERK KEY IS
PUSHED (1-10)
CLERK IS Y:POP-UP
N:STAY-DOWN
DRAWER NEEDS TO BE
SHUT TO OPERATE
ACTIVATE OPEN
DRAWER ALARM
SECONDS TO ALLOW
DRAWER OPEN
ALLOW POST TENDER
OPEN DRAWER ON
POST TENDER
ALLOW MULPTIPLE
RECEIPT
CASH DECLARATION
REQ BEFORE REPORTS
MGR CONTROL TO
TEND.
NEGATIVE BALANCE
ZERO BALANCE
RESET TRANSACTION #
ON Z REPORT
SAM4s SPS-300 Operator's & Programming Manual v1.34
Entry Description
Y or N Select N for a silent keyboard.
N
Select PUSH for a push button clerk, select CODE for
0 or 1
a code entry clerk system (number - clerk or clerk -
number - clerk) sequence.
1-10 If PUSH system is selected, you can select the clerk
that is signed on when the CLERK # key is pressed.
Note that the maximum clerk number you can enter
here is determined by how many clerks are allocated in
memory.
Select Y for pop-up clerks, select N for stay down
Y or N
clerks. With pop-up clerks, you must sign on for each
transaction. With stay down clerks, the same clerk
remains signed on until sign off.
Y or N Select Y to enforce closed drawer for register
operations.
Y or N Select Y if you want the error tone to automatically
sound when the drawer stays open longer than the time
set in the following field.
1-99 If you enable the open drawer alarm above, you can set
the length of time (1-99 seconds) before the alarm
sounds.
Y or N Select Y to allow re-tendering should a second change
calculation be necessary. Re-enter the tendered amount
and press the CASH key to show the new change
computation.
If you enable post tendering, select N to not open the
Y or N
cash drawer after the second tender.
Set to Y if you wish to issue more than one copy of a
Y or N
transaction receipt.
Y or N Select Y to enforce a cash declaration function before a
report can be generated.
Y or N Select Y if you wish to control negative transactions
(when cash is removed from the drawer). When
selected the control lock must be in the X position to
finalize the transaction.
Select Y if you wish to reset the transaction number
Y or N
(often called the receipt counter) to zero after the
financial report is reset.
Program Mode Programming • 177