Tare - Sam4s SPS-300 Series Operator's And Programming Manual

Removing a Function from a Function Look Up Key
To eliminate a function from a function key, you can replace the key assignment on the
function Look Up key with the inactive key code (#445). Remove functions from the bottom
of the list up, i.e. first remove the function at position #8, then #7, etc.
Beginning at firmware version 1.071, the inactive code is listed when you press PAGE
DOWN or PAGE UP to select a function from the list. (Press PAGE UP to view the end of
the function list where the INACTIVE function is located.) The inactive code was not listed
in previous firmware versions, however it was possible to enter the code "445".
SAM4s SPS-300 Operator's & Programming Manual v1.34
3. Enter the number of the menu position (there are eight functions listed on each
function look up menu) that you wish to edit, press CASH.
FUNC #1 MENU ASSIGN.
MENU NUMBER :
CURRENT ASSIGNMENT
ENTER NEW FUNC CODE,
PRESS CASH
4. Type the code for the function you wish to place on the function look up key
menu, press CASH. See "Function Key Codes" in the "Service Mode
Programming" chapter, or press PAGE DOWN to view a list of functions and
codes.
5. Go to step 2 above and continue to program menu numbers for the function look
up key, or press CLEAR to return to the PROGRAM MODE menu.
CANCEL
Program Mode Programming • 219
1
0
