Sensor (Tray 2 Pass-Through) Late-Arriving Or Late-Leaving Jam Service Check - Lexmark M52 Series Service Manual

Action
Step 30
Check the source tray controller board and its connector pins for
damage.
Are the tray controller board and its connectors free of damage?
Step 31
Replace the source tray controller board. See
sheet tray controller board removal" on page
Does the problem remain?
Sensor (tray 2 pass‑through) late-arriving or late‑leaving jam service check
Action
Step 1
Check the paper path and trays for paper fragments and partially
fed paper.
Is the paper path free of paper fragments and partially fed paper?
Step 2
Remove the paper fragments and partially fed paper.
Does the problem remain?
Step 3
Make sure that all the trays and tray inserts are properly installed.
Does the problem remain?
Step 4
Enter the Diagnostics menu, and then navigate to:
Input tray quick print >select source tray > Single
Does the problem remain?
Step 5
a
Enter the Diagnostics menu, and then navigate to:
Additional input tray diagnostics > Sensor tests
b
Find the sensor (Pass-through (tray 2)).
Does the sensor status change while toggling the sensor?
"250‑ and 550-
506.
Diagnostics and troubleshooting
139
Yes No
Contact the next Go to step 31.
level of support.
Contact the next The problem is
level of support. solved.
Yes No
Go to step 3. Go to step 2.
Go to step 3. The problem is
solved.
Go to step 4. The problem is
solved.
Go to step 5. The problem is
solved.
Go to step 9. Go to step 6.
4064