Mazda 1990 323 Workshop Manual Supplement page 98

J3
TRANSAXLE AND TRANSFER UNIT
DISASSEMBLY
Precaution
1, Clean the transaxle exterior thoroughly with a steam cleaner and/or cleaning solvent before disassembly.
2. Clean the removed parts (except sealed bearings) and all sealing surfaces with cleaning solvent, and dry
with compressed air. Clean out all holes and passages with a compressed air, and check that there are
no obstructions.
3. Wear eye protection when using compressed air to clean components.
5th/Reverse Gear and Housing Parts
1. Measure the thrust clearance between 5th gear and the transaxle case, referring to Preinspection.
2. Disassmble in the order shown in the figure, referring to Disassembly Note.
3. Inspect all parts and repair or replace as necessary.
03UOJ3-02
J3-20