Mazda 1990 323 Workshop Manual Supplement page 209

TROUBLESHOOTING GUIDE
K2
5
NO CREEP AT ALL
*Vehicle does not move in D, S, L, and R ranges when idling
DESCRIP-
*Road condition: flat paved road
TION
Note
l S range HOLD mode creep reduced because transaxle in 2nd gear position
[TROUBLESHOOTING HINTS]
3 ATF level low
3 Powertrain slippage (Forward clutch, reverse clutch, low and
reverse brake, one-way clutch 1 or one-way clutch 2)
3 Control valve stuck (Pressure regulator valve or manual
valve)
@ Oil pump worn
$$ Torque converter worn
a Hydraulic circuit clogged or leaking (Forward clutch, reverse
clutch, low and reverse brake, one-way clutch 1 or one-way
clutch 2)
TEP INSPECTION
ACTION
1 Check if ATF level is OK
Yes Go to next step
w page K2-134
Level:
Between notches on HOT side of level
gauge at 65°C (149OF)
HOT RANGE
No
Add ATF to specified level w page K2-134
2
Check if ATF condition is OK
Yes Go to next step
w page K2-134
@ Clear pink: Normal condition
@ Dark or black (with friction material): Worn
powertrain components
@ Milky pink: Water contamination
@ Light to dark brown (Oxidation): Overheated
or old fluid
No No.2 condition
Overhaul transaxle and repair or
replace parts as necessary
w page K2-134
No.3 or No.4 condition
Replace ATF
K2-33