Mazda 1990 323 Workshop Manual Supplement page 390

1990 mazda 323 4-wheel drive workshop manual supplement

Hide thumbs Also See for 1990 323:

Table of Contents

AND TRANSFER

PREMAIN CONTROL VALVE BODY

Disassembly / Inspection

Each valve should slide out/in under its own weight.

When a valve will not slide out under its own weight, depending

on the valve, push it out it

with a wire or place the valve body open-side down and lightly tap it with a soft hammer. Never

scratch or otherwise

damage a valve surface or bore.

Do not drop or lose the valves or internal parts.

Before assembly,

make sure all parts are thoroughly

Apply ATF to all parts and bores.

Note the proper direction

of the valves and internal parts.

Do not reuse any part that has been dropped.

Wrap a screwdriver

or rod with a tape before using it to insert a valve.

1. Disassemble

in the order shown in the figure.

2. Inspect all parts and repair or replace

as necessary.

in the reverse order of disassembly,

Show Quick Links

Chapters

Table of Contents