Mazda 1990 323 Workshop Manual Supplement page 511

REAR DIFFERENTIAL
Iv1
I
03UOMX-871
97UOMX-084
Mark
08
11
14
.-
17
20
23
26
Thickness
3.08mm
10;.;;;3
(0.1224 in)
3.14mm
(0.1236 in)
3.17mm
(0.1248 in)
3.20mm
'o;;yg$,
(0,127t in)
3.26mm
(0.1283 rn)
Mark
29
32
35
38
41
44
47
Thickness
3.29mm
'o;lIgi;~'
'c$&o7$)
'";$!JJll'
(0.1331 in)
3.41mm
y3$3~)
to.1354 in)
3.47mm
(0.1366 rn) 1
97UOMX-085
03UOMX-87
03UOMX-87
e) Place the SST atop the drive pinion model. Set the gauge
body atop the gauge block.
f) Place the feeler of the dial indicator so that it contacts where
the bearing inner race (side bearing) is installed in the car-
rier. Measure the lowest position on the left and right sides
of the carrier.
g) Add the two (left and right) values obtained in Step f, and
divide the total by 2.
Specification: Omm (0 in)
h) If it is not within specification, adjust the pinion height by
selection of a spacer.
Note
.
l
Spacers are available in increments of 0.03mm. Se-
lect the spacer thickness that is closest to that
necessary.
Adjustment of drive pinion preload
1 m Install the spacer.
Note
l
Press the bearing on until the force required sud-
denly increases.
l
Install the spacer selected from the pinion height
adjustment above, being careful that the installa-
tion direction is correct.
2. Press the bearing inner race (rear bearing) on with the SST.
Caution
l
Do not install the oil seal.
3. Install the collapsible spacer.
4. Install the drive pinion assembly.
5.
Install the companion flange, and tighten the flange nut.
Tightening torque: 117 N*m (12 m-kg, 86 ft-lb)
M-27