Mazda 1990 323 Workshop Manual Supplement page 131

1990 mazda 323 4-wheel drive workshop manual supplement

Hide thumbs Also See for 1990 323:

Table of Contents

AND TRANSFER

g) Average the values obtained in Step f.

Specification:

h) If it is not within specification, adjust the pinion height by

selection of a spacer.

Spacers are available in increments

of 0.03mm. Se-

lect the spacer thickness

that is closest

of drive pinion preload

1, Install the spacer.

Install the spacer selected from the pinion height

above, being careful that the installa-

tion direction

Press the bearing on until the force required

denly increases.

2. Press the bearing inner race (rear bearing) on with the SST.

Do not install the oil seal.

3. Install the collapsible spacer.

4. Install the drive pinion assembly.

5. Install the companion flange, and tighten the flange nut.

117 N,m (12 m-kg, 86 ft-lb)

6. Turn the companion flange by hand to seat the bearing.

7. Measure the drive pinion preload.

Adjust the preload by tightening the flange nut.

.56 N,m (lo-16

cm-kg, 8.7-13.8

m-kg, 86-130

specified preload cannot be obtained, replace the col-

lapsible spacer with a new one and check again.

8. Remove the nut, washer, and companion flange.

Show Quick Links

Chapters

Table of Contents